Why my iPv4 address not showing in command prompt?

  • Thread starter Thread starter Gaurav Sarma
  • Start date Start date
G

Gaurav Sarma

Guest
My iPv4 addresses aren’t showing in the command prompt. Also when i try to login to my router with 192.168.1.1 (default gateway) the page doesn’t loads but if i search something else it does load. Also now my iPv4 default gateway is fe80::1%8 but earlier it was 192.168.1.1 Help pls!!

Continue reading...
 
You must log in or register to reply here.

Similar threads

G
Why my iPv4 address not showing in command prompt?
Replies
0
Views
3
Gaurav Sarma
G
V
Connect two PCs in different floors that linked to seperate network hubs with different ipv4 address and ipv4 default gateways via LAN cables
Replies
0
Views
9
Vahid Pourbarkhordar
V
V
Connect two PCs in different floors that linked to seperate network hubs with different ipv4 address and ipv4 default gateways via LAN cables
Replies
0
Views
3
Vahid Pourbarkhordar
V
M
My dell laptop is showing that startup repair couldn't repair your PC even after entering the recovery key through command prompt
Replies
0
Views
2
M.Nitish Kumar
M
R
Hard Disk Stopped Showing in Laptop after i run a command prompt command in Diskpart while removing write-protection.
Replies
0
Views
3
Rupesh Prakash
R
Back
Top