Viewsonic monitor suggests 2560x1440 resolution however this resolution is not available as a display resolution in Windows

  • Thread starter Thread starter Ralph A Borriello
  • Start date Start date
R

Ralph A Borriello

Guest
Hello, I have the equipment listed below: My monitor is suggesting a 2560x1440 resolution but this resolution is not available in windows. I installed the latest driver for the monitor and installed the latest driver for the graphics card, still no luck. I have two monitors attached and they are attached to the PC using HDMI cables. The PC only has two display ports on the back, so I needed to use a HDMI to display port converter. If anyone has any suggestions, it would be appreciated. Thank you RalphPC: Dell Optiplex 7010 Windows information: Edition Windows 10 Pro Version 21H1 Installed o

Continue reading...
 
You must log in or register to reply here.

Similar threads

E
Asus XG49V Native resolution not available 11th gen Iris XE internal graphics
Replies
0
Views
6
Eric P_866
E
J
How to activate a third monitor detected by system, will not display or allow for adjustment in settings?
Replies
0
Views
6
Joseph Stryzek
J
R
Why does only 1 of 2 LG 34WP65C monitors connected through a Surface Thunderbolt 4 Dock display the incorrect resolution (1920 x 1080)?
Replies
0
Views
10
Richard Light1
R
M
Windows 11 will not recognize Viewsonic PA503W Projector Native display (shows up as non PNP Monitor)
Replies
0
Views
11
Mike_Arizona
M
P
How to swap an old HDmonitor with a new 4K monitor in a dual monitor setup and apply same settings (resolution etc) to both monitors?
Replies
0
Views
6
Peter Samsøe Christensen
P
Back
Top