RE: Error number: 0x800A1391

[RCB]

Fixed ???? I think Explorer 7 is the culprit. Have re-installed with download
program on hard disk after complete un-instal. It was very slow to load. It
wasn't until I had a complete reinstal that it worked to allow manual updates
and number disappeared. Repair program tries did not work.

I now have another problem in that E7 has slowed my computer and it is
leaving a problem on closing. It has to close automatically but now needs a
button push.
"Access violation at address 02050200 in module iesdsg.dll Read of address
25202E67"

Some research has shown it to be Spyware Doctor. I am yet to confirm this.



"Rick G." wrote:

> I'm getting this error message and just before that it flashes something about
> Active X. It flashes too fast to read.
>
> Any ideas?

 

[RCB]

Spy Doctor was run and scan performed and then switched off as I do not run
it all the time and the error I last reported has now gone and everything
seems to e running smoothly again.


"RCB" wrote:

> Fixed ???? I think Explorer 7 is the culprit. Have re-installed with download
> program on hard disk after complete un-instal. It was very slow to load. It
> wasn't until I had a complete reinstal that it worked to allow manual updates
> and number disappeared. Repair program tries did not work.
>
> I now have another problem in that E7 has slowed my computer and it is
> leaving a problem on closing. It has to close automatically but now needs a
> button push.
> "Access violation at address 02050200 in module iesdsg.dll Read of address
> 25202E67"
>
> Some research has shown it to be Spyware Doctor. I am yet to confirm this.
>
>
>
> "Rick G." wrote:
>
> > I'm getting this error message and just before that it flashes something about
> > Active X. It flashes too fast to read.
> >
> > Any ideas?