Mouse pointer too small in software and fine when not

  • Thread starter Thread starter Tamara Reidda
  • Start date Start date
T

Tamara Reidda

Guest
I know this was already asked back in 2017, however, it was not answered for my issue. My mouse pointer becomes very small when using the CarveWright software 4 & 5. It is the correct size when I am outside the software. While pressing "F10" on the keyboard, it will change to the normal size, however, it will not stay that size unless I press F10 every time I use the mouse. CarveWright states it's a Microsoft issue - not theirs. Here are my specs for my computer if you feel it might help.System: 64-bit operating system, x64-based processor64-bit operating system, x64-based proce

Continue reading...
 
You must log in or register to reply here.
Back
Top